Home

• Left Coast KLR's News Page
  • Left Coast KLR's Press Release 1
  • Left Coast KLR's Press Release 2
  • Left Coast KLR's Press Release 3
• Left Coast KLR's General Info Page
  • Why should I come?
  • schedule
  • what you can fix
  • what to bring
• Left Coast KLR's Articles Page
  • balancer lever upgrade
    • images/removing countershaft cover.JPG
    • images/remove shift lever.JPG
    • images/ready to pull outer case bolts.JPG
    • images/outer case ready to pull.JPG
    • images/outer case pulled and swung over.JPG
    • images/setting up wrench for rotor bolt.JPG
    • images/removing rotor bolt.JPG
    • images/2008 set up to pull rotor.JPG
    • images/factory lever shot rotor off.JPG
    • images/crank parts and lever removed on towel.JPG
    • images/inner case installed ready for torque.JPG
    • images/2008 stock spring 325 miles.JPG
    • images/stretching spring.JPG
    • images/spring installed.JPG
    • images/with drill ready to install screws.JPG
    • images/2008 lever new lever in place.JPG
    • images/key punched.JPG
    • images/key and starter gear in place.JPG
    • images/torquing rotor bolt.JPG
    • images/rotor and upper starter gear in place.JPG
    • images/pin and bearings in place.JPG
    • images/all gears in place.JPG
    • images/torquing outer cover.JPG
  • Installing a torsion spring
    • images/eccentric.jpg
    • images/groove.jpg
    • images/7oclock hole.jpg
    • images/spring in place.jpg
    • images/ready to attach.jpg
    • images/attached.jpg
    • images/in groove.jpg
  • shark fin install
    • images/side main.jpg
    • images/side block on.jpg
    • images/front block on.jpg
    • images/rear main.jpg
  • Left Coast KLR's article 3
    • 2008 page 2
  • KLR650 balancer parts history
  • Super KLR Project
    • Super KLR Project page 2
• Left Coast KLR's Table of Contents Page
• Left Coast KLR's Search Page

Send mail to Webmaster with questions or comments about this web site.
Copyright © 2005 Left Coast KLR Society
Last modified: 04/14/08